About
About
The new 14.8mm turnbuckles are just like other turnbuckles, but the spacer is longer, which is perfect for use with the FLM extended arm kit.
The Killer RC Rear Turnbuckle Kit includes two polished billet aluminum spacers, and two heat-treated alloy steel turnbuckles. These high tensile alloy steel turnbuckles are specially heat treated, giving them greater strength than titanium or stainless steel. Then when you add the aluminum spacers you have a setup that is many times tougher than the stock setup. The aluminum spacers simply work by spreading out the forces to a larger area on the end of the arm and ball end, and takes much of the stress off of the steel turnbuckle. The spacers are 12mm long, which is the camber setting that the Baja comes with from the factory. Installation is easy. Just screw the turnbuckle into the arm, slide the spacer over the turnbuckle and tighten the ball end tight up against it. You should not be able to move or spin the spacer. The aluminum spacers will fit overtop of PhatDad turnbuckles. They will also fit overtop of Fast Eddy pro turnbuckles if you drill open the spacers' a little bit. Available in your choice of camber spacer length, 12mm or 9.5mm, or 14.8mm. |