About
About
Fits VP Hex DriveVented Clutch Bell ONLY (DDM Part #GT191)
- Custom machined 20T hardened steel pinion gear.
- When pinion is taken off the bell cannot fall back into clutch covers out of reach which can cause incorrect installation of stock bell/pinion design. - A solid shaft from the bell to the nut prevents any wobbling between the pinion and bell which is common with the stock design of keyed bell/pinion.
- You can check clutch wear without removing the clutch bell when used with an open carrier or a Vertigo vented clutch cover.
- Access holes for those running Elcon adjustable clutches.
- Pinions of various sizes available in the future...